Epson BrightLink Pro 1430Wi Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Проектор Epson BrightLink Pro 1430Wi. Epson BrightLink Pro 1430Wi 26 сторінок. Control pad and touch unit
Також для Epson BrightLink Pro 1430Wi: Початок роботи (6 сторінок)
Друкувати сторінкуDo not view the laser light using optical devices such as a magnifying glass within a range of 2.75 in. (70
mm).
Viewing at close range could cause injury to eyesight.
Connect the Touch Unit to the BrightLink Pro 1430Wi model only. Do not connect it to any other projectors
or devices.
Do not use the Touch Unit if you are using or near medical equipment such as a pacemaker.
The magnet within the Touch Unit generates electromagnetic interference which could cause medical equipment
to malfunction.
Keep magnetic storage media (for example, magnetic cards or electronic devices such as computers,
digital watches, or cell phones) away from the Touch Unit.
The magnets within the Touch Unit generate electromagnetic interference which could corrupt data or cause the
media or device to malfunction.
Installation Location
•
When powering the Control Pad using batteries, verify that the installation location meets the following
conditions:
•
Install the Control Pad on the same surface as the projection screen. If the projection screen and the
Control Pad installation point are uneven, install the Control Pad approximately 8 in. (20 cm) from the
edge of the screen.
•
Make sure there are no obstacles between the Control Pad and the projector (not including the Touch
Unit).
•
Use the optional Remote Control Cable Set (model ELPKC28, part number V12H005C28) to supply power
to the Control Pad in the following situations:
•
The required conditions above are not met.
•
The projection screen and the Control Pad installation point are uneven and the difference in height is
more than 2 in. (5 cm).
•
Multiple projectors are being used.
•
Before installing the Touch Unit, verify that the installation location meets the following conditions:
•
The Touch Unit can be secured to the surface with magnets or screws.
•
The surface is flat, smooth, and unwarped with no more than 0.2 in. (5 mm) of unevenness in any
direction on the screen surface.
Warning
Caution
0.2 in. (5 mm)