Cisco 8865 Посібник користувача - Сторінка 3

Cisco 8865 Video MPP User Guide

To swap between the two calls:

4. Use the Navigation button to highlight the Held call, then press the Resume softkey

To join both parties into a conference:

5. Use the Navigation button to highlight the Active call, then press Conf line softkey

Video Calls

The Cisco 8865 supports video calls with a built in video camera

1. Turn the ring on the camera clockwise to open the to open the shutter

2. Press the Self-view softkey and move the camera up and down to set the view

3. Make a call

When you are on a video call, you can view your incoming and your outgoing video at the same time,

which is known as Picture-in-Picture (PiP). Typically, the incoming video displays on the full screen

and a small inset screen shows the video from your camera

Use the Navigation

The Call Waiting feature enables the user to take two calls simultaneously

1. While on a call, when another call comes in press the Answer softkey (this places the

first call on hold)

To swap between the two calls:

2. Use the Navigation button to highlight the Held call, then press the Resume softkey

While on a call you can place the call on Mute, this prevents the caller from hearing you, but you can

still hear the caller. To mute a call:

Press

2. Press

Adjusting the Ringer and Volume

1. Press -/+ to adjust the ring volume when the phone is idle or use to adjust

the volume of the other party while on an active call

There are two ways of transferring a call – Blind (direct transfer) and Consult (announced transfer).

Blind Transfer

1. During a call, press the BlindXfer softkey

2. Dial the other destination phone number

3. The call will transfer directly

Cisco 8865 Video MPP User Guide

button to move the PiP around the screen

during an active call.

again to un-mute the call.

23/06/20