Cisco Cisco Access Registrar 4.2 Налаштування мережевих параметрів - Сторінка 26

Переглянути онлайн або завантажити pdf Налаштування мережевих параметрів для IP-телефон Cisco Cisco Access Registrar 4.2. Cisco Cisco Access Registrar 4.2 34 сторінки. Telepresence conference system
Також для Cisco Cisco Access Registrar 4.2: Посібник користувача (44 сторінок), Посібник для початківців (46 сторінок)

Друкувати сторінку

Cisco Cisco Access Registrar 4.2 Налаштування мережевих параметрів

Modifying VLAN Settings

Configuring VLAN Settings

Using the Phone Configuration Web Page

Step 1

Step 2

Step 3

Cisco Unified IP Phone Administration Guide for Cisco Unified CallManager 4.2, Cisco Unified IP Phone

4-26

You can change the administrative VLAN used by the Cisco Unified IP Phone

and, on the Cisco Unified IP Phone 7905G and 7912G, you can disable or enable

VLAN manually.

This section covers the following topics:

Configuring VLAN Settings, page 4-26

•

Disabling VLAN, page 4-27

•

If you configure an administrative VLAN manually, that setting overrides the

auxiliary VLAN configured on a Cisco Catalyst switch in which the phone is a

member.

To assign an administrative VLAN for the Cisco Unified IP Phone, follow these

steps:

Procedure

Display the Phone Configuration web page.

For instructions, see the

Configuration Web Page" section on page

In the pane on the left under Change Configuration, click Network Parameters.

You may be prompted to enter a password.

The Network Parameters web page appears.

In the VLANSetting field, enter a VLAN ID into bits 18–29 and click Apply.

For more information about this field, see the VLANSetting parameter in

Table A-5 on page

A-16.

Chapter 4

Configuring Network Settings on the Cisco Unified IP Phone

"Accessing Network Settings through a Phone

4-2.

OL-8617-01