Ricoh SP 311SFNw Посібник для початківців - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник для початківців для Принтер "Все в одному Ricoh SP 311SFNw. Ricoh SP 311SFNw 47 сторінок. Network settings guide
Також для Ricoh SP 311SFNw: Посібник зі швидкого встановлення (2 сторінок), Технічні характеристики (4 сторінок), Технічні характеристики (4 сторінок), Посібник з монтажу (2 сторінок)
Друкувати сторінку
Manual Method
If your router doesn't support WPS, for instance older routers, there are two ways to manually configure
wireless LAN settings, using
Monitor
utility (via your computer).
Important:
You will need to know the security method being used, e.g., if the authentication method is WPA2-PSK,
•
you'll need the Passphrase). This can be determined by accessing your
with your corporate Help Desk.
Using Infrastructure Mode*
Infrastructure mode is the printer's default communication mode, as
most Wi-Fi networks function in this mode. This enables you to connect
the device for communication through a single access point, i.e., your
wireless router.
To configure Infrastructure mode, proceed as follows:
1. Press [User Tools].
2. Scroll down [] to [Network Settings], and press [OK].
3. Select [Wi-Fi], and press [OK].
4. Scroll to [Setup Wizard], and press [OK].
5. Select [Infrastructure], and press [Next].
Display reads, Searching Scan List...
6. Select discovered router Network Name, e.g., NETGEAR30 or select [Input SSID] and enter/edit
manually via alphanumeric keys.
7. Press [Next].
8. Scroll down to, for example, [Mixed Mode WPA2/WPA], and press [Next].
9. Enter case-sensitive Passphrase via alphanumeric keypad, and press [Connect].
Display reads, Are you sure to connect?
10. Press [Yes].
Display reads, Executing....
11. After display returns to Setup Wizard, press [User Tools] to exit.
12. Turn printer power switch Off. Wait a moment, and turn On.
13. Check wireless connection status.
Display should read, Connected. To exit, press [Clear/Stop].
Note:
Also see
Appendix A: Check Wi-Fi Connection
•
14. Next, install Network Printer/Scanner Drivers, as outlined in
*Ad-Hoc mode, also known as "peer-to-peer" mode, is also supported. Ad-Hoc networks do not require a
centralized access point. Instead, devices on the wireless network connect directly to each other. For
instance, if you set up the two laptops in Ad-Hoc wireless mode, they would connect directly to each
RICOH SP 311SFNw B&W Multifunction Laser Printer
(via control panel) or using the embedded
Infrastructure Mode
Press [User Tools]
router's web page
[Network Settings]
Status.
3.2 Network Quick
Getting Started Guide
Web Image
or consulting
[Wi-Fi]
[Wi-Fi Status].
Install.
14