Ricoh Pro C9200 Тренінг Cip - Сторінка 3

Переглянути онлайн або завантажити pdf Тренінг Cip для Принтер Ricoh Pro C9200. Ricoh Pro C9200 16 сторінок. Using the auto color diagnosis function
Також для Ricoh Pro C9200: Інструкція з експлуатації Посібник з експлуатації (48 сторінок), Поради (49 сторінок), Інструкція з експлуатації Посібник з експлуатації (24 сторінок), Посібник (32 сторінок)

CIP Training Pro C9200 series

Loading Paper

Do not stack paper over the limit mark

•

Jams and misfeeds can occur when printing on thick glossy sheets. To prevent such problems, be sure to

fan glossy sheets thoroughly before loading them.

When loading paper, set the paper direction according to its grain, as shown in the following diagram:

Direction of paper

grain

• Even if paper is loaded as described above, normal operations and print quality might still not

be possible, depending on the paper type.

• Prints might be noticeably curled. Flatten out prints if they are creased or curled. For details

about settings for flattening out curled paper, see "0301–0303 Correct Output Paper Curl",

Maintenance and Management.

• To prevent multiple sheets from being fed at once, fan the paper before loading it.

• If you load paper when only a few sheets of paper remain in the tray, multiple sheet feeding

may occur. Remove any remaining paper, stack them with the new sheets of paper, and then

fan the entire stack before loading it into the tray.

• Straighten curled or warped paper before loading.

• When paper in trays that are set to automatically eject unnecessary tab stock sheets runs out,

reload the tab stock from the beginning of the cycle (the first sheet).

• When you load paper into the paper tray for the first time or when you change the size or type

of paper in the paper tray, be sure to specify the appropriate paper settings in Tray Paper

Settings.

• You might at times hear a rustling noise from paper moving through the machine. This noise

does not indicate a malfunction

A3/11 × 17 tray unit,

Tray 1

Tray 2, or the wide LCT

Not recommended

Multi bypass tray (Tray A)