Ricoh Ri 1000 Посібник з усунення несправностей - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з усунення несправностей для Принтер Ricoh Ri 1000. Ricoh Ri 1000 27 сторінок. Procedure for long-term storage
Також для Ricoh Ri 1000: Посібник користувача (9 сторінок), Посібник користувача з технічного обслуговування (7 сторінок), Посібник (22 сторінок)
Друкувати сторінку
printing or before
cleaning)
8) Cartridge reads 0%
but was just at a high
% (example 65%) at
the previous
operation. (before
printing or before
cleaning)
9) During a fill cycle -
filling with cleaning
fluid or filling with
ink. The sequence
completes but one or
more of the
cartridges % change is
low (less than 5%)
and the lines to
appear correct (if ink
to cleaning fluid - ink
is still present is some
lines, if cleaning fluid
to ink then ink has
not completely filled
in some lines)
Ink pump has timed out and
ink was not detected in the
damper and the chip on the
ink cartridge will be written
to 0% . In this case, the
cartridge will remain reading
0% even after a restart of the
printer - possibly
accompanied by an Ink pump
time out error
Temporary loss of Comm
caused a channel to not
completely fill
still reads 0 after reinserting the
cartridge then turn the printer off
and turn it back on and the cartridge
will read correctly
1) Release the carriage and make
sure that the feeler for that channel
is not obstructed (see Detail below)
2) If no obstruction for the feeler
then check the ink line for that
channel to ensure the is no kink or
possible air leak (See detail below)
3)If this continues to occur then
check the connections to the ink
supply unit - the ink supply unit
may have to be replaced as the ink
pump may be failing (See Detail
below)
To complete charging you can either
- perform the opposite charging
operation - (if ink - fluid was initially
attempted then perform fluid to ink,
put ink carts back or if fluid to ink
was attempted then perform ink to
fluid). After the charging is
complete. Perform the original
charging operation. OR - You can
reset the flag in the service menu to
the ink stage the printer was in prior
to performing the operation. The
states you can choose are 1) After
ink charging 2) After cleaner
charging 3) After ink with out White
- Choose the stage the printer was
in prior to performing the fill cycle
(for example if it was full of ink you
can set this to after ink charging)
then you can repeat the charging
operation. (See detail below)