Ricoh ST23 Посібник з експлуатації - Сторінка 39

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Ксерокс. Ricoh ST23. Ricoh ST23 47 сторінок.

REPLACEMENT AND ADJUSTMENT

5.2 STAPLE POSITION ADJUSTMENT

[A]

NOTE: This adjustment should be performed when the main board or staple

unit is replaced.

X Direction

1. Check the position of the staple [A] on the copy paper.

2. Remove the upper cover [B] (4 screws),open the vertical transport door

[C] and remove the left front cover [D] (4 screws).

3. Lower the staple unit [E] by manually turning the timing belt [F] of the

staple unit positioning motor in the direction of the arrow.

4. Remove the staple unit upper cover [G] (1 screw).

5. Loosen the two screws [H] and adjust the staple unit position.

6. Retighten the screws [H].

Y Direction

1. Check the position of the staple [A] on the copy paper.

2. Remove the rear cover.

3. Adjust the staple position by setting the DIP SW101.

[C]

[F]

[B]

[D]

[E]

6 March 1992

[G]

[H]