Ricoh CF5010 Посібник з експлуатації - Сторінка 26
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Аксесуари для принтерів Ricoh CF5010. Ricoh CF5010 35 сторінок. Cover feeder
Друкувати сторінку
15 Jan 2013
CF-201
Fault Code CF-201, indicates that during Run, the Paper path / DSD sensor (CF-Q30), was not
blocked in time.
Initial Actions
Check fuse F2 on Transformer.
Make sure that the Paper path / DSD photo transistor sensor, and the Paper path / DSD LED
sensor (CF-Q30) is installed correctly.
Ensure that the Paper path / DSD sensor (CF-Q30) is clean.
Procedure
Enter the Service mode and select Paper path / DSD sensor (CF-Q30) in check sensors. Block, then unblock, the CF-Q30
with a sheet of paper. The Paper path / DSD sensor (CF-Q30) sensor indicates D:0 when the sensor is blocked and D:1
when the sensor is not blocked.
Y
N
Go to CF-009
1. Clean the feed rollers.
2. Make sure that the Jam clearance baffle is installed correctly.
3. Make sure that nothing interferes with the paper path in the Cover feeder.
CF-202
Go to CF-009 Paper path / DSD sensor is faulty
CF-203
Fault Code CF-203, indicates that during Run, the Paper positioning sensor (CF-Q32), was not
blocked within timeout.
Initial Actions
Check fuse F2 on Transformer.
Make sure that the Paper positioning sensor (CF-Q32) is installed correctly.
Ensure that the Paper positioning sensor (CF-Q32) is clean.
Procedure
Enter the Service mode and select Paper positioning sensor (CF-Q32) in check sensors. Block, then unblock, the CF-Q32
with a sheet of paper. The Paper positioning sensor (CF-Q32) sensor indicates D:0 when the sensor is blocked and D:1
when the sensor is not blocked.
Y
N
Go to CF-010
1. Clean the feed rollers.
2. Make sure that the Jam clearance baffle is installed correctly.
3. Make sure that nothing interferes with the paper path in the Cover feeder.
CF-204
Fault Code CF-204, indicates that during Run, the Paper positioning sensor (CF-Q32), was blocked
exceeding timeout.
Initial Actions
Check fuse F2 on Transformer.
Make sure that the Paper positioning sensor (CF-Q32) is installed correctly.
Ensure that the Paper positioning sensor (CF-Q32) is clean.
Procedure
Enter the Service mode and select Paper positioning sensor (CF-Q32) in check sensors. Block, then unblock, the CF-Q32
with a sheet of paper. The Paper positioning sensor (CF-Q32) sensor indicates D:0 when the sensor is blocked and D:1
when the sensor is not blocked.
Y
N
Go to CF-010
1. Clean the feed rollers.
2. Make sure that the Jam clearance baffle is installed correctly.
3. Make sure that nothing interferes with the paper path in the Cover feeder.
X03258 CF5010e Service manual
CF-4-7