Ricoh G348 Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з монтажу для Аксесуари для принтерів Ricoh G348. Ricoh G348 4 сторінки. Service tables duplex unit
Також для Ricoh G348: Посібник з монтажу (4 сторінок)
Друкувати сторінку
While supporting the duplex reversal unit, remove the
stopper of the printer's mounting bracket.
ZDJP046J
This stopper will be used in a later step
, so take care not to lose it.
While supporting the duplex reversal unit, remove the
adhesive tape, and then hold the auxiliary bar in front of
the hook on the left side, and then stand it up.
ZDJP047J
Hook the hole of the auxiliary bar onto the printer's
mounting bracket.
ZDJP048J
In step
, move the auxiliary bar to the position with the perforated line, as
shown.
Hang the auxiliary bar on the far left end, as shown, and
then install the stopper removed in step
ZDJP049J
Make sure the auxiliary bar and stopper are installed in the positions, as shown.
All manuals and user guides at all-guides.com
.
Slowly raise the duplex reversal unit, and then fold it up
to the printer.
ZDJP050J
Remove the adhesive tape holdings the cable, and then
connect the cable from the duplex reversal unit to the
upper connector on the back of the printer.
ZHXH260J
This completes installation of the duplex reversal unit. Install the duplex feed
unit after the external tray.
Install the external tray.
Stand the external tray, and then insert it from the
left side using both hands.
ZHXH270J
Pushing the right edge of the external tray
lightly with your finger (
ZDJP053J
), insert it (
).