Ricoh LCIT RT5090 Посібник з польового обслуговування - Сторінка 41

Переглянути онлайн або завантажити pdf Посібник з польового обслуговування для Аксесуари для принтерів Ricoh LCIT RT5090. Ricoh LCIT RT5090 42 сторінки. Machine code: d732

Друкувати сторінку

1. Safety, Conventions, Trademarks

Adjustment

Side Registration Adjustment

Normally the side registration of the image can be adjusted with SP1002-004 to -006 (Side-to-Side

Registration – Tray 1, 2, 3). When the punch hole positions are not aligned from a particular feed

station, adjust the side registration by changing the tray cover position for the tray, as described below.

Then adjust the side registration of the image with the SP1002.

1. Pull out the tray.

2. Change the screw positions [A] at both the right and left sides as shown.

• Adjustment range: 0 ± 2.0 mm adjustment step: 0.5 mm/step

Double Feed Problem from LCIT

If double feed occurs several times when paper is fed from an LCIT (Tray 1, 2 or 3), try to change the

upper limit of the paper stack in the LCIT tray. Changing the upper limit of the paper stack in the LCIT

tray can improve paper separation for the paper stack in the LCIT tray.

1. Remove the paper feed unit of the LCIT unit (page 13 "Paper Feed Units").

2. Loosen the screw on the paper lift sensor bracket [A].

3. Move the bracket 0.5 mm in the arrow direction as shown above.

Adjustment