Ricoh S7 D3DS Посібник з польового обслуговування - Сторінка 22
Переглянути онлайн або завантажити pdf Посібник з польового обслуговування для Аксесуари для принтерів Ricoh S7 D3DS. Ricoh S7 D3DS 23 сторінки. Double-feed kit
Друкувати сторінку
1.Install
22. Rotate the rear cover up [B].
23. Fasten the top edge of the rear cover at [A] and [B].
24. Attach the cover screw cover plate [A], and then lower the feed cover [B].
Final Adjustments
Before you can use double-feed detection you must first enable the double-feed detection setting, and then set the
detection sensitivity.
1.
Make sure that the machine is fully reassembled.
2.
Connect the machine to the power source and turn it on.
3.
Go into the SP mode.
4.
Open SP6040-001, and then set it to "1" (On). This enables double-feed detection.
5.
Next, open SP6040-008 to adjust double-feed sensitivity.
6.
Set an original in the ADF, and then press [Start]. (If you set more than one original, only one will feed.)
7.
Touch "EXECUTE" to feed one sheet
20