Cisco 10000 Series Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережевий маршрутизатор Cisco 10000 Series. Cisco 10000 Series 14 сторінок. Cisco systems router installation guide
Також для Cisco 10000 Series: Інформаційний бюлетень про продукцію (12 сторінок)

Друкувати сторінку

To perform the upgrade, follow these steps:

On the active ESR-PRE1, issue the write memory command to make sure the startup configuration is

Step 1

up to date.

Copy the saved startup configuration to a TFTP server and edit the configuration to reflect the new

Step 2

capabilities of the 12.2(28)SB software. At a minimum, you must edit the boot system variable to point

to the new image, using the boot system bootflash:image_name command and specifying your chosen

image name.

Remove both ESR-PRE1s, and install one ESR-PRE2 in one open slot. Make sure you have direct

Step 3

console access to the ESR-PRE2.

Step 4

The boot image should load itself from bootflash (the expected behavior). If the ESR-PRE2 comes up in

ROM monitor, type boot to load the boot image.

Configure the network management interface (typically FastEthernet 0/0/0) and the gateway IP address

Step 5

the same as they were on the removed ESR-PRE1s to enable communications with the TFTP server.

Copy the edited startup configuration from the TFTP server to your startup configuration using the copy

Step 6

tftp startup command.

Copy the 12.2(28)SB image from the TFTP server to bootflash, being sure to use the same name for the

Step 7

image that you specified in

Enter the reload command and type no when asked if you want to save your running configuration.

Step 8

If the ESR-PRE2 config-register is set to 0x2, this command will autoboot the new image.

If the ESR-PRE2 config-register is set to 0x0, it will come up in ROM monitor. Boot the new image from

ROM monitor using the boot bootflash:image_name command.

After the ESR-PRE2 is up and running the new image, verify that the Cisco IOS version, configuration,

Step 9

boot variable, and traffic are as expected.

Shut down the FastEthernet 0/0/0 interface on the first ESR-PRE2 using the shut command. Then insert

Step 10

the second ESR-PRE2 and repeat

ESR-PRE2 has booted, use the no shut command on the active ESR-PRE2 to activate the FastEthernet

0/0/0 interface again.

Now the system should be operating as a dual-PRE redundant 12.2(28)SB system in the configured mode

(either SSO or RPR+), running the properly modified startup configuration. You can verify the

redundancy status using the show redundancy or show redundancy state command.

Enter the write memory command from the active console to bring the startup configuration up to date

Step 11

on the active and standby ESR-PRE2s.

Rollback Procedure for Option 1

To roll back to the ESR-PRE1 configuration:

Remove both ESR-PRE2s and reinstall the ESR-PRE1s.

Step 1

The ESR- PRE1s should operate as they did in the original setup.

OL-8833-01

Step 2

for the boot system variable in the startup configuration.

Step 4

through

Step 8

Upgrading to Cisco IOS Release 12.2(28)SB on a Cisco 10000 Series Router

Upgrade Option 1: ESR-PRE1 Upgrade with Cold Start

for the second ESR-PRE2. After the second