Cisco 12000 - Series Chassis Modular Expansion Base Інструкція із заміни Посібник із заміни - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція із заміни Посібник із заміни для Мережевий маршрутизатор Cisco 12000 - Series Chassis Modular Expansion Base. Cisco 12000 - Series Chassis Modular Expansion Base 40 сторінок. Internet router line card failures
Також для Cisco 12000 - Series Chassis Modular Expansion Base: Технічний паспорт (9 сторінок), Оглядовий посібник (6 сторінок), Посібник з усунення несправностей обладнання (18 сторінок)
Друкувати сторінку
Table 2
Cisco 12000 Series Router PRP.
Table 2
Total Route Memory
512 MB
1 GB
1 GB
1.5 GB
2 GB
1. Do not mix memory sizes. If installing 2 DIMMs, both DIMMs must be the same size.
2. Default SDRAM configuration is 512 MB. Bank 1 (U15) must be populated first. You can use one or both banks to configure
3. One 512-MB DIMM is the default shipping configuration.
4. Upgrades PRP to 1 GB by adding a second 512-MB DIMM.
5. This memory size is not supported.
If your system includes redundant PRPs, both PRPs should have the same memory size. Redundancy is
Note
not supported when using a GRP and a PRP in the same chassis. Cisco strongly recommends that you
avoid configuring your router using mixed route processor cards. Refer to the Route Processor
Redundancy Plus for the Cisco 12000 Series Router publication for more redundancy information.
Line Card Memory
There are two types of user-configurable line card memory on most line cards:
•
•
Line card memory configurations and memory socket locations differ, depending on the type of line card.
In general, all line cards share a common set of memory configuration options for route memory, but
support packet memory differently. For clarity in describing how to remove and install memory in this
publication, line cards fall into the following groups, based on certain physical characteristics:
•
•
•
•
Note
78-4338-16
lists the available route memory configurations and associated product numbers for the
Route Memory Configurations Available for Cisco 12000 Series Router PRP
1
Cisco Product Number
3
—
MEM-PRP-512=
MEM-PRP-1G=
5
—
2MEM-PRP-1G=
SDRAM combinations of 512 MB, 1 GB, or 2 GB. 1.5 GB configurations are not supported.
Route or processor memory
Packet memory
Engine 0 and Engine 1 line cards (See
Engine 2 line cards (See
Figure
Internet Service Engine (ISE), formerly known as Engine 3 line cards (See
Engine 4 and Engine 4+ line cards (See
The procedures for replacing memory on both the Engine 4 and the Engine 4+ line cards is
identical.
DIMM Modules
1 512-MB DIMM
4
2 512-MB DIMMs
1 1-GB DIMM
—
2 1-GB DIMMs
Figure
3.)
4.)
Figure
6.)
Cisco 12000 Series Router Memory Replacement Instructions
GRP, PRP, and Line Card Memory Overview
SDRAM DIMM
2
Sockets
U15
U15 and U18
U15
—
U15 and U18
Figure
5.)
7