Cisco 1700 series Посібник з встановлення обладнання - Сторінка 36

Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Мережевий маршрутизатор Cisco 1700 series. Cisco 1700 series 46 сторінок. Secure firewall management center
Також для Cisco 1700 series: Посібник з дотримання нормативних вимог та інформації про безпеку (45 сторінок), Посібник (15 сторінок), Посібник з конфігурації (25 сторінок), Примітка до заявки (41 сторінок), Усунення несправностей обладнання (12 сторінок), Оглядовий посібник (13 сторінок), Налаштування (34 сторінок), Посібник (5 сторінок), Посібник із швидкого старту (6 сторінок)

Rack-Mount the Chassis

• A standard 19-inch (48.3-cm) wide, 4-post EIA rack with mounting posts that conform to English universal

• The rack post holes can be square 0.38-inch (9.6 mm), round 0.28-inch (7.1 mm), #12-24 UNC, or #10-32

• The minimum vertical rack space per chassis must be 1 RU, equal to 1.75 inch (44.45 mm).

• The slide rails for the chassis have an adjustment range of 24 to 36 inch (610 to 914 mm).

Note

Safety Warnings

Warning

Note

Step 1

Attach the inner rails to the sides of the chassis:

a) Align an inner rail with one side of the chassis so that the three keyed slots in the rail align with the three pegs on the

side of the chassis.

Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide

hole spacing per section 1 of ANSI/EIA-310-D-1992.

UNC when you use the supplied slide rails.

The slide rails supplied by Cisco Systems for the chassis do not require tools for installation if you install

them in a rack that has square 0.38-inch (9.6 mm), round 0.28-inch (7.1 mm), or #12-24 UNC threaded holes.

Take note of the following warning:

Statement 1006 Chassis Warning for Rack-Mounting and Servicing

To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions

to ensure that the system remains stable. The following guidelines are provided to ensure your safety:

• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.

• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the

heaviest component at the bottom of the rack.

• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing

the unit in the rack.

Statement 1032 Lifting the Chassis

To prevent personal injury or damage to the chassis, never attempt to lift or tilt the chassis using the

handles on modules, such as power supplies, fans, or cards. These types of handles are not designed to

support the weight of the unit.

Statement 1098 Lifting Requirement

Two people are required to lift the heavy parts of the product. To prevent injury, keep your back straight

and lift with your legs, not your back.

Rack-Mount the Chassis