Cisco 1841 - 3G Bundle Router Посібник із швидкого старту - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережевий маршрутизатор Cisco 1841 - 3G Bundle Router. Cisco 1841 - 3G Bundle Router 28 сторінок. Integrated services router with aim-vpn/bpii-plus integrated services router with aim-vpn/epii-plus fips 140-2 non proprietary security policy
Також для Cisco 1841 - 3G Bundle Router: Технічний паспорт (11 сторінок), Посібник користувача (29 сторінок), Посібник користувача (9 сторінок)
Друкувати сторінку
Console, Auxiliary, and USB Port Connections
The connections described in Table 2 provide system management access.
Note
The USB port (version 1.1) is intended for future use only.
Table 2
Console and Auxiliary Port Connections
Port or Connection
Color or Type
Console
Light blue
Auxiliary
Black
USB
—
Power Connections
Connect the router power cord to a 15A, 120 VAC power source or 10A, 240 VAC power source.
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 15A, 120VAC (10A, 240VAC). Statement 1005
Note
The input voltage tolerance limits for AC power are 85 and 264 VAC.
6
Power Up the Router
Checklist for Power Up
You are ready to power up the Cisco 1841 router after the following steps are completed:
• Chassis is securely mounted and grounded. (See the "Install Chassis" section on page 4.)
• Power and interface cables are connected. (See the "Connecting Cables" section on page 13.)
• Make sure that the external CompactFlash memory card is properly seated into the slot. For installation instructions, refer
to the online Cisco 1800 series hardware installation documentation at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/1800/hw/index.htm
• PC with terminal emulation program is connected to the console port, powered up, and configured for 9600 baud, 8 data
bits, 1 stop bit, no flow control, and no parity.
• Suitable PC COM port is selected in the terminal emulation program.
Note
For initial power up, a direct console connection is recommended. After the initial configuration is completed, a remote
modem connection can be used for router management.
Caution
To ensure adequate cooling, never operate the router unless the cover and all modules and cover plates are installed.
Connected To:
PC or ASCII terminal communication
port (usually labeled COM)
Modem for remote access
Peripheral devices
Cable
RJ-45-to-DB-9 console cable
RJ-45-to-DB-9 console cable and
DB-9-to-DB-25 adapter
USB cable
15