Cisco 1841 - 3G Bundle Router Посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник користувача для Мережевий маршрутизатор Cisco 1841 - 3G Bundle Router. Cisco 1841 - 3G Bundle Router 9 сторінок. Integrated services router with aim-vpn/bpii-plus integrated services router with aim-vpn/epii-plus fips 140-2 non proprietary security policy
Також для Cisco 1841 - 3G Bundle Router: Посібник із швидкого старту (28 сторінок), Технічний паспорт (11 сторінок), Посібник користувача (29 сторінок)
Друкувати сторінку
Powering Up Cisco 1800 Series Routers
This section covers the following topics:
•
•
•
Checklist for Power Up
You may power up the Cisco router if the following steps have been completed:
•
•
•
•
•
For initial power up, we recommend a direct console connection. After the intial configuration is
Note
completed, a remote modem connection can be used for router management.
To ensure adequate cooling, never operate the router unless the cover and all modules and cover plates
Caution
are installed.
To prevent damage to the ejector mechanism, the ejector button next to the CompactFlash memory card
Caution
must remain fully seated when not being used to eject a CompactFlash memory card.
LED Indicators
The meanings of the LED indicators for Cisco 1800 series routers are summarized in
detailed information about the LEDs, see
(Modular)."
Power-Up Procedure
To power up your Cisco router and verify that it completes its initialization and self-test, follow this
procedure. When you have completed the procedure you may begin configuring the router.
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
7-2
Checklist for Power Up, page 7-2
LED Indicators, page 7-2
Power-Up Procedure, page 7-2
Mount and ground the chassis securely.
Connect the power and interface cables.
Make sure that the external CompactFlash memory card is properly seated into its slot. For
installation instructions, see
Series Routers
(Modular)".
Connect a PC to the router's console port.
Start HyperTerminal or a similar terminal emulation program on your PC. Select the appropriate PC
COM port. Set the terminal emulation program configuration for 9600 baud, 8 data bits, 1 stop bit,
no flow control, and no parity.
Chapter 7
Power-Up Procedures for Cisco 1800 Series Routers (Modular)
"Installing and Replacing CompactFlash Memory Cards on Cisco 1800
Chapter 8, "Troubleshooting Cisco 1800 Series Routers
Table
2-5. For more
OL-5876-03