Cisco 2524 - Router - EN Посібник з конфігурації - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник з конфігурації для Мережевий маршрутизатор Cisco 2524 - Router - EN. Cisco 2524 - Router - EN 23 сторінки. Troubleshooting guide
Також для Cisco 2524 - Router - EN: Посібник з конфігурації (23 сторінок), Огляд (10 сторінок), Підготовка до встановлення (19 сторінок), Посібник з усунення несправностей (4 сторінок)

Configuring the Router

Step 8

Step 9

Step 10

Conﬁguring Switched 56

This section explains how to conﬁgure the 2-wire switched 56-kbps and 4-wire 56/64-kbps

DSU/CSU WAN modules for switched 56-kbps circuit-switched service.

You can conﬁgure the 2-wire switched 56-kbps DSU/CSU WAN module for

switched 56-kbps service, but not Digital Data System ([DDS], which are leased or

dedicated lines). The 4-wire 56/64-kbps DSU/CSU WAN module is conﬁgured for DDS as

the factory default, but it can be conﬁgured for either switched 56/64-kbps service or DDS.

(See the next section, "Conﬁguring DDS.")

For Cisco IOS Release 11.0 and earlier releases, refer to the Router Products Command

Reference for more information about the commands in this section. For Cisco IOS

Release 11.1 and later releases, refer to the Conﬁguration Fundamentals Command

Reference.

Take the following steps to conﬁgure the 2-wire switched 56-kbps and 4-wire 56/64-kbps

DSU/CSU WAN module for circuit-switched service, substituting the correct addresses and

host names as appropriate for your network:

Step 1

Step 2

4-16 Cisco 2524 and Cisco 2525 Router User Guide

Conﬁgure a static route to allow connectivity to the target router's local network.

Enter the network number of the target router's local IP network and subnet mask,

and the IP address of the target router's BRI port.

Router (config)# ip route targetrouter_ipnetwork subnetmask

targetBRIport_ipaddress

Enter the exit command to exit conﬁguration mode.

Enter the copy running-conﬁg startup-conﬁg command to save the

conﬁguration to NVRAM.

Enter enable mode:

Router> enable

password: enablepassword

Enter conﬁguration mode:

Router# config term

Router(config)#