Cisco 2610 - Router - EN Посібник із швидкого старту - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережевий маршрутизатор Cisco 2610 - Router - EN. Cisco 2610 - Router - EN 19 сторінок. Cisco 2610: quick start
Також для Cisco 2610 - Router - EN: Технічний паспорт (8 сторінок)

Друкувати сторінку

1. Quick Start Guide

Run Cisco Fast Step

Timesaver

Cisco Fast Step software

prompts you for network information

according to the routing protocols you

select. Before you run the software, make

sure you have this information available or

know where to get it (usually from the

network administrator).

For your convenience, a form prompting

you for setup information is on page 11.

Install and Run Cisco Fast Step

Insert the Cisco Fast Step CD-ROM (attached to

inside back cover of this guide) into the

CD-ROM drive of the local PC to which you

connected the LAN on page 5.

The Fast Step install program starts Setup.exe

automatically. If it does not, follow these steps:

(a) Double-click the My Computer icon.

(b) Double-click the CD icon.

The install program prompts you for the

information it needs to install Cisco Fast Step,

then copies the software onto your hard drive.

Set Up the Router

Using Fast Step

Once installed, the Cisco Fast Step Setup program

starts automatically. Follow the onscreen

instructions to guide you through conﬁguring and

testing the router.

Verify Connectivity

Perform this test to verify the modem connection and

the router conﬁguration are good. This section

assumes the remote PC you are using for the test runs

Windows NT 4.0 or Windows 95.

Double-click the My Computer icon on the

desktop of the remote PC.

Double-click the Dial-Up Networking folder. (If

you do not ﬁnd this folder, refer to the Microsoft

documentation to install the software.)

Double-click the Make New Connection icon.

Follow the onscreen instructions to create and

name a new connection icon to test the modem

connection and the router conﬁguration. When

prompted for the area code and telephone

number, enter the appropriate number of the

modem you are testing.

Double-click the new connection icon you

created in Step 4 and enter the username and

password (as deﬁned when setting up Fast Step).

Verify that the telephone number is the correct

number for the modem you are testing.

Go to page 10 to connect the remaining modem

cables, if necessary.