ActronAir LC7-2G Інструкція з монтажу Посібник з монтажу - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Блок управління ActronAir LC7-2G. ActronAir LC7-2G 8 сторінок. Wall control
Друкувати сторінку
Installation Guide
4. Press the PROG button to accept changes. Display will show the zone CLOSE percentage and LOW. By default this will
be 0. Press the
NOTE
CLOSED and LOW range is 0-45%, with 5% increments per the
5. Press the PROG button to accept changes and return to the zone selection screen. Press the EXIT button to return to
Service Menu.
09. Advance Series Self-Learn Mode (EVV Indoor Models)
1. Ensure all connected zones have been detected or enabled.
2. Before activating, ensure the following:
• Return air filter, box and grille are properly installed.
• All doors or any other restrictions that may obstruct the air path back to the return and grille are open.
• Adjustable outlets should be in open position and System Air Balance should be complete.
09.01. Initiating Self-Learn Mode
1. System should be in the OFF MODE before activating self-learn mode.
2. Press and hold the FAN button and
release.
3. Press the FAN button once and release.
4. AUTO will flash on the controller display during operation of self-learn mode.
NOTES
• If a self-learn passes PAS will display on the wall controller.
• If a self-learn fails, FAL will display on the wall controller.
• To return to Main Menu, press EXIT.
• To cancel Self-learn Mode, press
or
buttons to change value.
button for 5 seconds or until the word Lrn appears on the display and
Note: Refer to Service Manual for troubleshooting.
button or EXIT.
LC7-2 Control Interface Insert
Document: 9590-3024 Ver. 2 200702
LC7-2 Control Interface
or
buttons press.
07