Cisco 2801 - Integrated Services Router Посібник із швидкого старту - Сторінка 34

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережевий маршрутизатор Cisco 2801 - Integrated Services Router. Cisco 2801 - Integrated Services Router 47 сторінок. 2800 series integrated services routers
Також для Cisco 2801 - Integrated Services Router: Посібник користувача (29 сторінок), Технічний паспорт (20 сторінок)

Друкувати сторінку

Cisco 2801 - Integrated Services Router Посібник із швидкого старту

Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the

Step 6

console port:

The virtual terminal password is used to protect

access to the router over a network interface.

Enter virtual terminal password: xxxxxx

Respond to the following prompts as appropriate for your network:

Step 7

Configure SNMP Network Management? [yes]:

Community string [public]:

A summary of the available interfaces appears:

The interface numbering that appears is dependent on the type of Cisco modular router platform and on the

Note

installed interface modules and cards.

Current interface summary

Controller Timeslots D-Channel Configurable modes Status

T1 0/0/0

T1 0/0/1

T1 0/2/0

T1 0/2/1

Any interface listed with OK? value "NO" does not have a valid configuration

Interface

GigabitEthernet0/0

GigabitEthernet0/1

GigabitEthernet0/3/0

Choose one of the available interfaces for connecting the router to the management network:

Step 8

Enter interface name used to connect to the

management network from the above interface summary: fastethernet0/0

Step 9

Respond to the following prompts as appropriate for your network:

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: no

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 16 subnet bits; mask is /16

Step 10 The configuration is displayed:

The following configuration command script was created:

hostname Router

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

no ip routing

interface FastEthernet0/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.1.2.3 255.255.0.0

pri/channelized

IP-Address

OK? Method Status

20.0.0.40

YES DHCP

unassigned

Administratively up

unset

Protocol