Cisco 4000 Series Посібник з монтажу - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережевий маршрутизатор Cisco 4000 Series. Cisco 4000 Series 18 сторінок. Upgrading memory
Також для Cisco 4000 Series: Посібник (18 сторінок), Підготовка до встановлення (11 сторінок), Посібник із заміни (16 сторінок), Посібник з оновлення (24 сторінок)

Overview of Telco Rack-Mounting and Wall-Mounting

Installing Telco Rack-Mount or Wall-Mount Brackets into a New Version of the Chassis

Take the following steps to install telco rack-mount or wall-mount brackets into the new version of

the chassis:

Step 1

Step 2

Step 3

Note

screw locations apply only to the wall-mount procedures.

Figure 15

19 x 19" or larger plywood

board (if wall-mounted)

14 Cisco 4000 Series Rack-Mount and Wall-Mount Installation

Remove the component tray from the system. Refer to the procedure described in the

section, "Preparing the Chassis for Rack-Mounting or Wall-Mounting."

Insert one rack-mount bracket into the slot on each side of the chassis shell, lining up the

bracket with the screw holes located on the side of the chassis shell.

Fasten each bracket to the side of the chassis shell using four 8-32 ﬂat-head machine screws

(as shown in Figure 15).

Figure 15 shows screw locations for both telco rack-mounting and wall-mounting. The wood

Screw Locations for Telco Rack-Mount or Wall-Mount Brackets – New Version of the

Chassis

8-32 flat-head

machine screws

Wood screws

Telco rack-mount or

wall-mount bracket

Chassis shell

Front of the chassis