Actsoft LMU-5000 Посібник з обладнання та інсталяції - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з обладнання та інсталяції для GPS Actsoft LMU-5000. Actsoft LMU-5000 8 сторінок.

Size and Placement of LMU Unit

The dimensions of the LMU should be taken into account, particularly when installing in

a vehicle:

Whether you intend to place the LMU under a seat or into a cavity behind the vehicle's

interior molded trim, be sure the LMU will fit before drilling any holes or running cable

•

Be certain that the cables running to the LMU will not be bent or constricted.

Damage to the cables may impede the LMU's performance.

•

Be certain that the installation point will not violate any of the LMU's

environmental specification (temperature, moisture, etc...) as improper

installation of the LMU may void the warranty.

Typical installations will place the LMU under the vehicle dash board, or in the trunk.

Make sure you can get access to the unit afterwards as under some circumstances it may

be necessary to add additional wiring or connections to the LMU.

It is best not to place the LMU unit in an unusually warm location such as directly near

heater vents, near hot engine components or in direct sunlight.

The LMU unit must be located where it will not be exposed to moisture or water. In a

typical installation inside a vehicle this is not commonly thought to be a concern;

however, it might be best to avoid locating the LMU below a car's cup holders, or where

rain might easily splash into the compartment when a door is opened.

Typically, the LMU should be placed under the passenger seat or dashboard of the

vehicle. LMUs with internal antennas should be placed to maximize their GPS

performance. A typical location include under the dash close to the front wind-shield.

Attach the LMU to the solid body of the vehicle, not to plastic panels. The LMU can be

placed out of sight by removing interior trim and molding to expose available space, then

replacing the trim once the LMU is in place.

Status LED lights on the front of the LMU unit can provide valuable information about

the operation of the LMU. When feasible, attempt to install the LMU in such a way that

these lights can be seen with reasonable ease.

You may find it useful to be able to view the LEDs periodically to make sure that the

LMU is operating properly. If at any time you should encounter a problem with the

LMU, you may need to read the LEDs in order to troubleshoot the problem. If you cannot

fix the LMU yourself, you will need to provide the LED information to CalAmp

customer support.