CAB 5314 Посібник оператора - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник оператора для Виробник етикеток CAB 5314. CAB 5314 17 сторінок. Vacuum-belt applicator
Друкувати сторінку
4
Adjustments
i
Note!
The alignment of the applicator to the printer is fixed according to factory standards and should not be
altered to ensure a safe label application. Only the angle to the printer may be changed.
4.1
Setting the Angle to the Printer
max 30°
Fig.9
Setting the angle to the printer
Warning!
!
Take care when loosening screw (1). The device drops due to its own weight.
Loosen screws (1) to adjust the angle and thus the depth of the applicator to the printer.
Set the angle or depth of the product and tighten the screws (1). 4.2 Adjust the Setup of the Printer
4.2
Adjusting the Setup of the Printer
The configuration parameters of the applicator can be found in the menu Setup > Machine param.
Speed
i
Note!
The speed of the belt and the label transportation will set by the parameter Support del. OFF.
The value is displayed in ms and not in real value used mm/s.
i
Note!
It's necessary to set exact the values in the table.
Deviations will result in automatic defaulting back to the standard value of 100.
Parameter to set the speed of the belts.
Four steps are available.
100 ms :
150 ms :
220 ms :
300 ms :
500 ms :
> Support del. OFF
100 mm/s speed of the transportation belt
150 mm/s speed of the transportation belt
220 mm/s speed of the transportation belt
300 mm/s speed of the transportation belt
500 mm/s speed of the transportation belt
1
13