CAB EOS5 Посібник з експлуатації - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Виробник етикеток CAB EOS5. CAB EOS5 20 сторінок.
Також для CAB EOS5: Посібник оператора (15 сторінок)
Друкувати сторінку
2
Replacing Assembly Units
14
2.9
Replacing the PCB CPU
Danger!
Risk of death via electric shock!
Before opening the housing cover, disconnect the device from the mains supply and wait at least one
minute until the power supply unit has discharged.
1
2
2
Fig. 10
Replacing the PCB CPU
1. If possible, save the printer configuration to an external medium Configuration Manual.
2. Unplug the printer from the electrical outlet.
3. Detach all interface cables from the back of the printer.
4. Remove all memory media from the slots.
5. Remove the casing..
6. Unplug all plug connections (4-10) from the PCB CPU (1).
7. Unlock the latches (3) and remove the PCB CPU from the pins (2).
8. Put the PCB CPU onto the pins (2) and snap it in into the latches (3).
9. Connect all cables (4-10) to the PCB CPU.
10. Mount the casing.
11. Restore all interface connections on the back of the printer.
12. Connect the power cable.
13. Update the firmware if necessary.
14. Adjust the label sensor Configuration Manual.
15. Load the printer configuration from the memory medium if possible. Otherwise, set the printer configuration via
control panel Configuration Manual.
2
3
1 PCB CPU
4
2 Pins
3 Latches
5
Connectors:
6
4 CON13 - Gear motor
5 CON12 - Control panel
6 CON11 - Sensors
7
7 CON10 - Printhead
8 CON9 - Power supply
9 CON8 - Stepper motor
8
10 CON7 - Cable cutter connection
9
3
2
10
14