Cisco Nexus 9000 Series Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережевий маршрутизатор Cisco Nexus 9000 Series. Cisco Nexus 9000 Series 12 сторінок. Switch chassis
Також для Cisco Nexus 9000 Series: Посібник зі швидкого налаштування (6 сторінок), Посібник з конфігурації (32 сторінок), Посібник з конфігурації (32 сторінок), Посібник (30 сторінок), Встановлення (8 сторінок), Посібник із швидкого старту (14 сторінок), Посібник (16 сторінок)

Installing the Switch

b) Attach the guide to the chassis using two M4 screws (see Callout 4 or 8 in the previous figure). Tighten the screws

to 12 in-lb (1.36 N·m) of torque.

c) Repeat Step 2 for the other rear rack-mount bracket on the other side of the switch.

Step 3

Install the slider rails on the rack or cabinet as follows:

a) Determine which two posts of the rack or cabinet you should use for the slider rails. Of the four vertical posts in the

rack or cabinet, two will be used for the front mount brackets attached to the easiest accessed end of the chassis, and

the other two posts will have the slider rails.

b) Position a slider rail at the desired level on the back side of the rack and use two 12-24 screws or two 10-32 screws,

depending on the rack thread type, to attach the rails to the rack (see the following figure). Tighten 12-24 screws to

30 in-lb (3.39 N·m) of torque and tighten 10-32 screws to 20 in-lb (2.26 N·m) of torque.

Figure 2: Installing the Slider Rails

Slider rail with screw holes aligned to screw holes in

rack

c) Repeat Step 3 to attach the other slider rail to the other side of the rack.

To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count

the screw holes in the vertical mounting rails.

Step 4

Insert the switch into the rack and attach it as follows:

Cisco Nexus 9372TX ACI-Mode Switch Hardware Installation Guide

Two customer-supplied 12-24 or 10-32 screws used

to attach each slider rail to the rack

Installing the Switch Chassis