CAB 4214R-200 Інструкція з монтажу Посібник з монтажу - Сторінка 11
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Промислове обладнання CAB 4214R-200. CAB 4214R-200 14 сторінок. Stroke-turn applicator
Друкувати сторінку
4
Operation
4.3
Movement of the Pad
The applicator 4214 has different modes for picking up labels. The position of the pad can also be adjusted to suit
different applications of the labels.
The standard position of the pad will be described in Service Manual. The take up mode is mainly dependant
on the size and material of the label. In the standard settings the applicator will ignore the interim steps of "Label
hand-over up."
No
Movement of the pad
Pad to the dispensing plate of the printer
1
(take up the label)
Pad departs from the dispensing plate of the
2
printer
Pad will swing out via a rotation cylinder
3
Pad moved to the inclined position below the
4
dispensing plate of the printer and stops
Pad will swing in via a rotation cylinder
5
Pad moves in the swing in position to the
6
product and applies the label
Pad moves in the swing out position to the
7
product and applies the label.
* Take the label via vacuum and support air with a distance between pad and dispensing plate of the printer.
Table 2
Steps of tamp movement
4
7
Fig. 6
Movement of the pad
3
Dispensing plate
1
of the printer
2
5
6
Product
Label
Label
hand-over
hand-over
up,
up,
apply 0°
apply 90°
swing
swing
X
X
X
X
X
X
X
X
X
X
Hand-over up switch aktive on/off
Menu navigation:
HERMES Q
Setup
>
>
Labeling
> Label hand-over
Passive / Active
Hermes+
Setup
> Machine param.
> Applicator
> Hand-over up
Off / On
Label swings out and applies
This function will be controlled by the I/O
interface of the printer.
The signal LBLROT (EDR - Hermes+) on Pin
24 will be used to control this function.
Operator's Manual of the printer
Label apply
Label apply
0° swing
90° swing
*
*
X
X
X
X
X
X
11