CAB CAB CL.ES.RR Інструкція з експлуатації Посібник з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Блок управління CAB CAB CL.ES.RR. CAB CAB CL.ES.RR 17 сторінок.

Друкувати сторінку
ANT
M
ALL
4
7) SW1 ADJUSTMENT
The SW1 jack adjusts the possible re-opening of the sun shade curtain after a wind alarm:
SW1 jack open:
SW1
Op. Cl.
Op. Cl.
COM
SW1 jack closed:
20
Km/h
SW1
45
1
Km/h
Km/h
15

8) INSTALLATION RESET

Km/h
At first installation, after checking the good operation of the
35
1
Km/h
Km/h
wind alarm, when the wind speed is reached the sun shade
SW
curtain must close. To avoid waiting for 8 minutes, power the
20
Km/h
ON
control unit on and off.
9) HOW TO PROGRAMME THE TRANSMITTER (14 tran-
45
1
Km/h
Km/h
1
smitters max)
15
Km/h
To programme the transmitter, press and release the SP2
key: the L2 LED switches on and the buzzer makes a con-
35
1
Km/h
Km/h
tinuous sound. Press key 1 of the transmitter for around 4
seconds from the buzzer switching off. Release the transmit-
ter key and press it again for 2 seconds: the L2 LED flashes
three times and the buzzer makes an intermittent sound. The transmitter code is now stored in the memory
card.
If the intermittent sound is not heard for 15 seconds, repeat the above-mentioned steps.

10) HOW TO ERASE THE CENTRAL MEMORY

To erase all transmitter codes from the control unit memory, press the SP2 key and keep it pressed for 10-
15 seconds, until the red L2 LED starts flashing.
11) DISPLAY OF THE LEDs (L1, L2)
Red L2 LED flashes
Op. COM Cl.
Op. COM Cl.
MOT
2

TECHNICAL DATA

Contol unit supply
Fuse
Operating temperature
Time of work
Output supply
Power maximum motor
Protection level
Radio receiver
JM1
JM2
JM3
a b c
d e
when the wind alarm stops, the curtain moves again to the original position.
If the sun shade curtain was open, it will open again.
when closed, the curtain remains closed when a wind alarm triggers.
To re-open it, an opening control signal must be sent.
SP2
RT1
6
DL1
DL2
a wind alarm has triggered. The control unit sends a closing control signal to
Op. COM Cl.
all motors; they can start again for re-opening after 10 minutes.
MOT
MOT
3
ANT
f g
R
A
Tasto 1
D
CHIUDE
I
O
Tasto 3
APRE
4
230 Vac
2,5 A
-10°C / +60°C
2 minutes
1 motor 230 Vac
300W
IP56
433,92 MHz integrated
T4WV-C
25
Klux
12
Klux
8
Klux
0
Klux
Tasto 2
Tasto 4
32
Klux
45
Klux
50
Klux