Cisco XR 12816 Посібник з монтажу - Сторінка 27
Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережевий маршрутизатор Cisco XR 12816. Cisco XR 12816 41 сторінка. Cisco systems router owner's manual
Також для Cisco XR 12816: Інструкція з перепакування (26 сторінок)
Друкувати сторінкуChapter 1
Product Overview
PRP Reset Switch
Caution
OL-17440-01
Access to the (soft) reset switch is through a small opening in the PRP front panel
(see
Figure
1-11). To press the switch, insert a paper clip or similar small pointed
object into the opening.
The reset switch is not a mechanism for resetting the PRP and reloading the
Cisco IOS image. It is intended for software development use only. To prevent
system problems or loss of data, use the reset switch only on the advice of Cisco
service personnel.
Pressing the reset switch causes a nonmaskable interrupt (NMI) and places the
PRP in ROM monitor mode. When the PRP enters ROM monitor mode, its
behavior depends on the setting of the PRP software configuration register. For
example, if the boot field of the software configuration register is set to:
0x0—The PRP remains at the ROM monitor prompt (rommon>) and waits for
•
a user command to boot the system manually.
0x1—The system automatically boots the first Cisco IOS image found in
•
flash memory on the PRP.
Cisco XR 12416 and Cisco XR 12816 Router Chassis Installation Guide
Route Processor
1-27