Epson V11H180020-N - PowerLite Home 20 Посібник користувача - Сторінка 36
Переглянути онлайн або завантажити pdf Посібник користувача для Проектор Epson V11H180020-N - PowerLite Home 20. Epson V11H180020-N - PowerLite Home 20 50 сторінок. Epson esc/vp21 modem: users guide
Також для Epson V11H180020-N - PowerLite Home 20: Посібник з швидкого налаштування (7 сторінок), Посібник користувача (1 сторінок)
Друкувати сторінку
The picture is upside-down or reversed.
Change the setting for the
The image doesn't fit on the screen correctly, or it is stretched or compressed.
Press the
Check the
Use the
Position
page 19.
The picture is wider at the top or bottom.
You've tilted the projector to raise or lower the image, causing it to become "keystoned." Use
the
or
Better yet, place the projector at a height approximately between the top and bottom of the
screen, keeping it level, and then use the vertical lens shift dial to position the image (see
page 13). You won't have to correct for keystone distortion this way, and you'll get a
better-looking image.
The picture is taller on the left or right side.
The projector is set at an angle to the screen. Face it squarely toward the screen, and then use
the horizontal lens shift dial to center the image. See pages 12 and 13.
The picture contains static or noise.
Make sure your cable is securely connected at both ends.
Excessive cable length may cause interference. The practical length of the cable depends
on the type of cable used, its quality, and the complexity of your connections. Consider
using a signal amplifier.
If you're displaying the same image on your computer and projector screen, try turning
off your laptop's LCD display.
Check the settings in the
make sure they're correct for your video equipment. See page 20.
Make sure the
flickering while viewing still images, switch the setting to
36
Problem Solving
Projection
button to select a different aspect ratio. See page 14.
Aspect
and
Zoom Caption
setting in the Settings menu to reposition the image on the screen. See
button on the projector or remote control to correct the problem.
Keystone
Video Signal
setting is set to
Progressive
option in the Settings menu. See page 20.
settings. See pages 19 and 20.
Output Scaling
and
Input A
when viewing video. If you notice
OFF
options in the Settings menu to
. See page 19.
ON