Cisco 7200 VXR Series Посібник із швидкого старту - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Бездротова точка доступу Cisco 7200 VXR Series. Cisco 7200 VXR Series 48 сторінок. Preparing for installation
Також для Cisco 7200 VXR Series: Технічний паспорт (12 сторінок), Посібник (14 сторінок)
Друкувати сторінку
3
Rack-Mount the Router
Figure 4
Attaching the Rack-Mount Brackets to the Front of the Chassis
Cisco 7200
Series
3
1
1
Rack-mount bracket
2
Cable-management bracket
Brackets Front-Mounted—Chassis Protrudes from the Rack
Locate the rack-mount and cable-management brackets and screws and a Number 2 Phillips screwdriver.
Step 1
Align the rack-mount bracket (1)—as shown above—to the side of the router. Insert and tighten the screws (3) if you
are not adding the cable-management brackets. Repeat this step on the other side of the router.
Go to the "Two-Post or Four-Post Rack Installation" section on page 16.
Step 2
If you are using the cable-management brackets, align the rack-mount bracket (1) to the side of the router, align the
cable-management bracket (2) over the rack-mount bracket—as shown above—and insert the screws (3) through both.
Tighten the screws. Repeat this step on the other side of the router.
If you have an NPE-G1 or NPE-G2 installed, go to the "NPE-G1 and NPE-G2 Rear Cable-Management Brackets on a
Front-Mounted Router" section on page 12.
If you do not have an NPE-G1 or NPE-G2 installed, go to the "Two-Post or Four-Post Rack Installation" section on page 16.
10
ETHERNET 10BT
2
TOKEN RING
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
3
M4 x 8-mm Phillips flathead screws