Cisco 800 Series Посібник з проектування - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник з проектування для Бездротова точка доступу Cisco 800 Series. Cisco 800 Series 50 сторінок. Fast step software design guide
Також для Cisco 800 Series: Примітки до випуску (36 сторінок), Посібник із швидкого старту (13 сторінок), Посібник із швидкого старту (17 сторінок), Налаштування (32 сторінок)

CFG File Modification

Hide Central Router Name

Typically, when there is a single ISDN connection, it is not necessary to enter a central router name

parameter. The prompt for this parameter can be hidden from the end user. The flag syntax is as follows:

[PPPSettings]

HideCentralRouternameISP=

HideCentralRouternameRCN=

If the flag value is set to 0 or blank, the central router name is hidden.

If the flag value is set to 1, the central router name is shown.

The flag ISP extension refers to Internet service provider (ISP). The flag RCN extension

Note

refers to remote corporate network (RCN).

You can use this flag to force the router to reset to the factory default configuration. The flag syntax is

as follows:

[Setup Type]

SetRouterToDefaultConfig=

If the flag value is set to 1, the router is write-erased and rebooted without prompting the end user.

If the flag value is set to 0 or blank, after a connection to the router is established, Setup prompts the

user to append or erase the existing configuration.

Advice-Of-Charge (AOC) time-outs for the user connected to the NET3 switches is supported and

controlled using the flags SetAOCTimeout, which determines AOC timeout in seconds, and

AOCShortHoldTimeout, which determines the minimum idle time before the line is dropped. The

default is 120 seconds.

The flag syntax is as follows:

[ISDNSettings]

IdleTimeoutISP=

IdleTimeoutRCN=

SetAOCTimeout=

AOCShortHoldTimeout=

If the IdleTimeoutISP flag is set to 1, the router disconnects from the dialer when there in no traffic to

the ISP.

If the IdleTimeoutRCN flag is set to 1, the router disconnects from the dialer when there in no traffic

to the remote corporate network.

If the value of the SetAOCTimeout flag is set to 1, the dialer ISDN short-hold value time command

(where time is the number of seconds) is placed in the dialer map-class with a value equal to the

AOCShortHoldTimeout flag.

Cisco 800 Fast Step Software Design Guide

2-4

Chapter 2

CFG File Development

OL-10373-02