Cisco AIR-CAP3702E-Z-K9 Посібник для початківців - Сторінка 19
Переглянути онлайн або завантажити pdf Посібник для початківців для Бездротова точка доступу Cisco AIR-CAP3702E-Z-K9. Cisco AIR-CAP3702E-Z-K9 45 сторінок.
Друкувати сторінку
11
Troubleshooting
If you experience difficulty getting your access point installed and running, look for a solution to your
problem in this guide or in additional access point documentation. These, and other documents, are
available on Cisco.com.
You can access the Cisco support forum for more troubleshooting tips, at the following URL:
https://supportforums.cisco.com/community/netpro/wireless-mobility
Guidelines for Using Cisco Aironet Lightweight Access Points
Keep these guidelines in mind when you use 3702 series lightweight access points:
• The access point can only communicate with Cisco wireless LAN controllers.
• The access point does not support Wireless Domain Services (WDS) and cannot communicate with
WDS devices. However, the controller provides functionality equivalent to WDS when the access
point joins it.
• CAPWAP does not support Layer 2. The access point must get an IP address and discover the
controller using Layer 3, DHCP, DNS, or IP subnet broadcast.
• The access point console port is enabled for monitoring and debug purposes. All configuration
commands are disabled when the access point is connected to a controller.
Using DHCP Option 43
You can use DHCP Option 43 to provide a list of controller IP addresses to the access points, enabling
them to find and join a controller. For additional information, refer to the
43 and DHCP Option 60" section on page
Checking the Access Point LED
The location of the access point status LED is shown in
Regarding LED status colors: it is expected that there will be small variations in color intensity
Note
and hue from unit to unit. This is within the normal range of the LED manufacturer's
specifications and is not a defect.
39.
Figure
5.
"Configuring DHCP Option
19