Cisco AIR-CAP3702I-E-K9 Посібник для початківців - Сторінка 22
Переглянути онлайн або завантажити pdf Посібник для початківців для Бездротова точка доступу Cisco AIR-CAP3702I-E-K9. Cisco AIR-CAP3702I-E-K9 45 сторінок.
Друкувати сторінку
Troubleshooting the Access Point Join Process
Access points can fail to join a controller for many reasons: a RADIUS authorization is pending;
self-signed certificates are not enabled on the controller; the access point's and controller's regulatory
domains don't match, and so on.
Using the access point GUI, you can view join process failures in the AP Join Stats page. To view this
page, select Monitor > Statistics > AP Join, and then click the MAC address of the AP.
Alternatively, you can use the following CLI command to get a list of all APs that attempted to join
the controller:
show ap join stats summary all
To view details of a join process failure, use the following command:
show ap join stats detailed <ap base radio MAC address>
Controller software enables you to configure the access points to send all CAPWAP-related errors to
a syslog server. You do not need to enable any debug commands on the controller because all of the
CAPWAP error messages can be viewed from the syslog server itself.
The state of the access point is not maintained on the controller until it receives a CAPWAP join
request from the access point. Therefore, it can be difficult to determine why the CAPWAP discovery
request from a certain access point was rejected. In order to troubleshoot such joining problems
without enabling CAPWAP debug commands on the controller, the controller collects information for
all access points that send a discovery message to it and maintains information for any access points
that have successfully joined it.
The controller collects all join-related information for each access point that sends a CAPWAP
discovery request to the controller. Collection begins with the first discovery message received from
the access point and ends with the last configuration payload sent from the controller to the access
point.
You can view join-related information for up to three times the maximum number of access points
supported by the platform for the 2500 series controllers and the Controller Network Module within
the Cisco 28/37/38xx Series Integrated Services Routers.
The maximum number of access points varies for the Cisco WiSM2, depending on which
Note
controller software release is being used.
When the controller is maintaining join-related information for the maximum number of access points,
it does not collect information for any more access points.
An access point sends all syslog messages to IP address 255.255.255.255 by default when any of the
following conditions are met:
22