Cisco AIR-CAP3702I-E-K9 Посібник для початківців - Сторінка 39
Переглянути онлайн або завантажити pdf Посібник для початківців для Бездротова точка доступу Cisco AIR-CAP3702I-E-K9. Cisco AIR-CAP3702I-E-K9 45 сторінок.
Друкувати сторінку
English Translation
This equipment operates on a secondary basis and consequently must accept harmful interference,
including interference from stations of the same kind. This equipment may not cause harmful
interference to systems operating on a primary basis.
Declaration of Conformity Statements
All the Declaration of Conformity statements related to this product can be found at the following
location:
http://www.ciscofax.com
13
Configuring DHCP Option 43 and DHCP Option 60
This section contains a DHCP Option 43 configuration example on a Windows 2003 Enterprise DHCP
server for use with Cisco Aironet lightweight access points. For other DHCP server implementations,
consult product documentation for configuring DHCP Option 43. In Option 43, you should use the
IP address of the controller management interface.
DHCP Option 43 is limited to one access point type per DHCP pool. You must configure a
Note
separate DHCP pool for each access point type.
The 3700 series access point uses the type-length-value (TLV) format for DHCP Option 43. DHCP
servers must be programmed to return the option based on the access point's DHCP Vendor Class
Identifier (VCI) string (DHCP Option 60). The VCI string for the 3700 series access point is:
Cisco AP c3700
If your access point was ordered with the Service Provider Option (AIR-OPT60-DHCP)
Note
selected in the ordering tool, the VCI string for the access point contains ServiceProvider. For
example, a 3700 with this option will return this VCI string:
Cisco AP c3700-ServiceProvider
The format of the TLV block is listed below:
• Type: 0xf1 (decimal 241)
• Length: Number of controller IP addresses * 4
• Value: List of WLC management interfaces
To configure DHCP Option 43 in the embedded Cisco IOS DHCP server, follow these steps:
39