Argent Edo 400 Інструкція з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Внутрішнє оздоблення приміщень Argent Edo 400. Argent Edo 400 2 сторінки. Wall hung
Друкувати сторінку
INSPECT THE FURNITURE TO
ENSURE NO DAMAGE HAS
OCCURRED DURING TRANSIT.
IF DAMAGE HAS OCCURRED,
OR VISIBLE DEFECTS EXIST,
DO NOT PROCEED WITH
INSTALLATION AND ADVISE
ARGENT IMMEDIATELY.
F U R N I T U R E M U S T B E
FITTED THROUGH STUDS
INTO THE WALL. USE FIXING
BRACKETS PROVIDED.
IF STUD POSITIONING DOES
NOT ALIGN WITH FIXING
BRACKETS, CABINET MUST
BE ADDITIONALLY SECURED
THROUGH THE BACK BOARD
TO STUDS. IF NO STUDS
ARE FOUND TO SECURE
THROUGH, NOGGINS MAY BE
REQUIRED.
PRIOR TO INSTALLATION
Argent recommends a qualified trade
person fit your vanity. Ensure your
furniture is installed to relevant building
codes and Australian Standards.
Please note, Argent will not be liable
for the cost of installation or removal
of the furniture and the warranty will be
voided if damage occurred during or
after installation.
Fit wall hung basin at required height
to secure stud or frame, ensure level.
Fit plumbing.
Hold vanity over pipes in correct position.
(1)
Use
scrap blocks of wood to set at
just under correct height.
3
2
2
1
C
4
Ensure door is adjusted to
sit square as they may have
moved during transportation.
MEASURE & MARK
(2)
Find
in wall studs to secure to. Measure and mark
position for drilling. Fix through a stud where possible.
If no studs are found to secure through, special fixings
may be required. Use fixings appropriate to your wall
material.
FIT OFF, ADJUST & FINISH
C
Lift vanity to required height and secure appropriate
fixing mechanism into the wall. Drill securing screws
appropriate to your wall through furniture back board
in stud and wall.
Ensure door is adjusted to sit square as it may have
1
moved during transportation.
Put a bead of waterproof mastic compound around the
back edge of the basin and where the basin touches the
wall. Do not over tighten the basin bolts, to avoid
damaging the basin.
Door Adjustment
Vertical Adjustment
Forward & Back
Adjustment
Basin Sealing
I MP OR TA N T:
U S E ON LY b a th ro o m
g rad e si l i co n s ea l an t
Epoxy type glues
MUST NOT BE USED.
Put a bead of waterproof mastic
compound around the back
edge of the basin and where the
basin touches the wall. Do not
tighten the basin bolts to avoid
damaging the basin.
I M P OR TA N T:
INSPECT THE FURNITURE
TO ENSURE NO DAMAGE
HAS OCCURRED DURING
TRANSIT.
IF DAMAGE HAS
OCCURRED, OR VISIBLE
DEFECTS EXIST, DO
NOT PROCEED WITH
INSTALLATION AND ADVISE
ARGENT IMMEDIATELY.