Argent BETTE Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Ванни Argent BETTE. Argent BETTE 6 сторінок.

Access and Framing Continued

Where any of the edges of the whirlpool are in an alcove or will form part of or join the

walls, the plastic tiling bead supplied should be adhered to these edges using a suitable wet

area silicon sealant. Where the tiling bead forms a corner, this should be cut at a 45 degree

angle.

Complete the supporting framework of the whirlpool including allowance for the access

panel system. Do not sheet up yet!

Once you have completed the framework to the approved standard, with the whirlpool fitted

to its final position, the waste fitting can now be connected to the plumbing discharge/ waste

pipe.

Note

When framing up, please be aware of the fact that the control pads and various other fittings

may protrude below the rim of the whirlpool and care should be taken to avoid damage or

constriction of these fittings.

Figure 5, Access and Framing

Figure 6, Typical Framing Detail

8 Cleaning and care instructions

With the correct care and proper treatment, you will enjoy your whirlpool for a long time.

Your whirlpool can be cleaned easily and without significant effort if the following

techniques are employed.

Wipe your whirlpool down after use with a moistened soft cloth or chamois, if there is a

residue, you can additionally use mild detergent (dish washing liquid or mild soap) to assist

in the removal of any residue.

For lime deposits, remove these deposits with a vinegar solution diluted with water

(Ratio 1: 1)

Chrome plated fittings can also be cleaned with mild detergent and a soft cloth, polish with

a dry soft cloth afterwards.

For whirlpools without the optional sanitising system, the inside of the jets can be cleaned

by using a small bottle brush. The jets are directionally adjustable and non-removable.

Important Care and cleaning detail

Relative to cleaning product, Check the manufacture's instructions and warning notes before

using any type of cleaner on your whirlpool.

Use only soft cloths, sponges or chamois to clean the surface, under no circumstances should

scrubbing brushes/ sponges, steel wool or any tools be used.

Do Not Use any scouring or aggressive and or rough cleaning agents. Chorine based

disinfectants and aggressive cleaners (EG acetone, thinners etc) may attack and or bleach

the fittings or enamelled surface.

Cleaning frequency

Your whirlpool should be sanitised regularly, and the amount of times you initiate this is

relative to how often you are using the whirlpool, notwithstanding, this should happen no

less than once a year even if you have not used the whirlpool.