DigitaLinx DL-FHD2 Посібник користувача - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник користувача для Подовжувач DigitaLinx DL-FHD2. DigitaLinx DL-FHD2 18 сторінок.

Connecting a Display

HDMI Output

Connect the display devices to HDMI output on the receiver using an HDMI cable that is less than or equal to

5 meters in length. For display devices that are further away, it is highly recommended to utilize the HDBaseT

output�

Optical Input / Output

Connect a duplex LC-LC OM3 multimode fiber cable from the OPTICAL OUT of the transmitter to the OPTICAL IN

of the receiver. Be sure that you route the duplex fiber cable as numbered on the transmitter and receiver, i.e.

OPTICAL PORT 1(TX) - OPTICAL PORT 1(RX); OPTICAL PORT 2(TX) - OPTICAL PORT 2 (RX).

To ensure proper performance of the DL-FHD2, it is recommended that you use multi-mode OM3 fiber optic

cabling�

Connect Audio Input / Output

Connect a Toslink digital audio cable to the transmitter and receiver from AVR / display, use the audio mode

selection switch on the front of the transmitter and receiver to set the audio mode of choice. See page 11 for

audio mode selection status and page 12 for application diagrams for the physical routing of the desire mode.

DL-FHD2 Owners Manual