DigitaLinx DL-HDCAT Посібник користувача - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник користувача для Конвертер мультимедіа DigitaLinx DL-HDCAT. DigitaLinx DL-HDCAT 12 сторінок.

Ensure the two Category Cables are plugged into the appropriate RJ45 Jack. The wires
should be routed RJ45-1 to RJ45-1 and RJ45-2 to RJ45-2. Ensure the modular plugs are
fully seated and locked into the receptacles. High Frequency signals are very susceptible
to Electromagnetic Interference (EMI). It is strongly recommended to use overall shielded
Category cables where ever possible. Category 5e is the minimum cable recommended
and Category 6 is better.
The recommended method for connection of devices to the Digital Media Converter is
listed in the following steps. Please ensure this order is followed to enjoy the full function
of the device.
1) Ensure the digital video/audio source and display is turned off.
2) Connect the digital video/audio source to the input port of the Digitalinx™ Digital
Media Converter.
3) Connect the digital display to the output port of the Digitalinx™
Digital Media Converter.
4) Power up the Digitalinx™ Digital Media Converter.
5) Power up the digital display.
6) Power up the digital video/audio sources
7) HDCP handshaking operation can take up to 20 seconds. The Red LED will
go off on the Receiver when this is complete. The Green LED will illuminate
when complete.
8) Check the LED power indicator and status indicator on the Digitalinx™ Digital
Media Converter. The signal indicators should be green when the devices are
correctly attached. See troubleshooting on Page 1-10 if the LED is not green.
Note: The unit can function without the DC power supply however HDMI.org does not
recognize or authorize devices using source device voltage (Pin 18 on your video source) as
part of their specification. If using this item for DVI or Video only applications the DC power
source can be removed. It is recommended to use the DC power source for full operation of
the device.

Installation

1-6
Installation