Caberg DUKE EVO Посібник - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для Аксесуари для мотоциклів Caberg DUKE EVO. Caberg DUKE EVO 16 сторінок.

ENG

Your helmet DUKE EVO thanks to the double homologation P/J can be used in 2 configurations

(chinguard closed "P" and chinguard open "J")

Lever P/J

When the P/J lever is positioned on "J" it is possible to block the chinguard in the open position

( Pic.1). The selection on the position "J" can be done before opening the chinguard.

WARNING ! When in "J" position it is not possible to close the chinguard. Do not force the

closure, as this, could cause damages to the closing mechanism of the helmet.

To be able to close the chinguard it is necessary to move the P/J lever to the "P" position.

When the lever P/J is positioned on "P" the chinguard can be opened and closed (Pic.2)

WARNING!

The level of protection of this helmet is in function of the configuration adopted by the user:

full protection with the chinguard closed and partial protection when the chinguard is open.

Whilst on the move do not ride with the chinguard in the open postion if the P/J lever is

not positioned in the configuration "J".

1. HOW TO FIX AND REMOVE THE CLEAR VISOR

1.1 With the chin-guard closed, open the visor; push the release lever A towards the back of the

helmet and then release the visor (Pic. 3).

1.2 Repeat the same process on the other side and remove completely the visor.

To mount back the visor, repeat the above steps in reverse order.

2. INSTRUCTION TO REMOVE THE SMOKE SUN VISOR

2.1 Move the lever of the smoke sun visor towards the front of the helmet (Pic.4)

2.2 Release the smoke sun visor by lifting up, with a small flat screwdriver, the slider that holds it

to the lever (Pic.5)

2.3 Release the smoke sun visor by pulling slightly outwards (Pic.6)

3. INSTRUCTION TO ASSEMBLE THE SMOKE SUN VISOR

3.1 Clip the smoked visor accommodating its' side parts into their seating with a slight pression.

(Pic.7)

3.2 Drive forward the top lever (Pic. 4)

3.3 Drive the smoke sun visor inside until it engages the lever (Pic.7)

WARNING: Never use the smoke sun visor during the night or with scarce visibility condition.

WARNING: Any adjustments to the smoke sun visor must be done with the two-wheeler in still

position.

4. REMOVING AND MOUNTING THE CHIN GUARD

The chin guard of this helmet can be removed to ease the cleaning of the various mechanisms.

4.1 Repeat steps 1.1.

4.2 Loosen the screw B (Pic. 8).

4.3 Remove the chin guard.

Repeat the above steps in the reverse order to mount the chinguard back to its original position.

CAUTION! Never use the helmet without the chinguard.