Cisco Cisco Aironet Wireless LAN Client Посібник із швидкого старту - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Бездротова точка доступу Cisco Cisco Aironet Wireless LAN Client. Cisco Cisco Aironet Wireless LAN Client 12 сторінок.
Також для Cisco Cisco Aironet Wireless LAN Client: Посібник для початківців (38 сторінок)
Друкувати сторінку
3
Associate an IP Address with the Access Point
To open the access point management pages, you need the access point's IP address, which can be
obtained in one of two ways:
• If your network uses a DHCP server, the server automatically assigns an IP address to the access
point. Use the IP Setup Utility (IPSU) to identify the assigned address.
• If you are not connected to a DHCP server and the access point is on the same subnet as your PC,
use IPSU to assign an IP address to the access point.
Note You can also identify or set the access point's IP address by using the straight-through
9-pin serial extension cable in your access point package to connect the COM1 or COM2
port on your computer to the RS-232 serial port on the access point. Use a terminal emulator
to view the access point's express setup screen and write down the IP address. Use these port
settings for the terminal emulator session: 9600 baud, 8 data bits, no parity, 1 stop bit, and
Xon/Xoff flow control.
Using a DHCP Server
When you connect the access point to your network, it receives an IP address from the DHCP server.
If you have access to the DHCP server, you can use the management console to identify the IP address
for the access point. If not, you need to identify the assigned IP address using IPSU. Follow the
instructions in the "Finding the DHCP-Assigned IP Address" section on page 7 to determine the IP
address.
Using the IP Setup Utility
Note You must run IPSU from a computer on the same subnet as the access point.
Installing IPSU
Put the Cisco Aironet Access Point CD in the CD-ROM drive of the computer you are using
Step 1
to configure the access point.
Use Windows Explorer to view the contents of the CD. Double-click on the IPSU folder;
Step 2
double-click the setup.exe file.
Follow the steps provided by the installation wizard.
Step 3
5