Cisco WAP125 Посібник із швидкого старту - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Бездротова точка доступу Cisco WAP125. Cisco WAP125 14 сторінок. Wireless-ac/n dual band desktop access point with poe
Також для Cisco WAP125: Посібник із швидкого старту (13 сторінок), Посібник (10 сторінок)
Друкувати сторінку
Incorrect IP Address
The most likely cause of connectivity failure is an incorrect IP address. The Web
browser may be pointing to the wrong IP address, or your computer may be
configured with an IP address that is not in the same subnet as the Cisco WAP125.
Because the factory default IP address configuration is DHCP, make sure that your
DHCP server is running and can be reached. You may need to disconnect and
reconnect the devices for them to discover their new IP addresses from the DHCP
server. You can then query the DHCP server for the new IP address. See
Getting Started with the
Configuration
If the Cisco WAP125 does not receive a DHCP response (there is no DHCP server on
your network) after 60 seconds, the Cisco WAP125 will fallback to the following
default static IP address: 192.168.1.245 and a default mask of 255.255.255.0. To
reach that IP address, be sure that your computer is on the 192.168.1.xxx network.
8
Rebooting the Cisco WAP125 or Resetting to
Factory Defaults
To reboot your Cisco WAP125:
• If the Cisco WAP125 uses a power adapter, with the power on, use the POWER
button to reboot the device. The POWER button only functions when the Cisco
WAP125 uses a power adapter.
• If the power supply is PoE, unplug your Ethernet connection for three seconds
and plug it back in.
• With the power on, press the RESET button with an opened paper clip for less
than 10 seconds, or until the lights go off.
–
When all the lights go off, release the RESET button.
–
Release the RESET button as soon as the lights go off, or you will restore
the Cisco WAP125 to factory default settings and lose your configurations.
To reset the Cisco WAP125 to factory default settings:
• With the power on, press and hold the RESET button with an opened paper clip
for more than 10 seconds.
–
All of the lights will go off.
–
Release the RESET button when the power light turns on.
8
for more information on how to find the DHCP address.
Cisco WAP125 Quick Start Guide
Step 2
of