CABINETS TO GO Findley & Myers BBC45 Інструкція з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу для Внутрішнє оздоблення приміщень CABINETS TO GO Findley & Myers BBC45. CABINETS TO GO Findley & Myers BBC45 4 сторінки. Blind base cabinets
Також для CABINETS TO GO Findley & Myers BBC45: Інструкція з монтажу Посібник з монтажу (10 сторінок)
Друкувати сторінку
Instructions:
►
1.
Place the face frame (A) face down on a flat soft working surface to ensure that the face is not
scratched or damaged.(Figure1).
2.
Installing the Side Panels (Figure 2): Insert right and left side panels (B) into the grooves of
the face frame (A) and align the cam lock connectors (Figure 2). Lock the cam with a
screwdriver by turning the screw 180° clockwise. (Figure4).
3.
Installing t he B ottom (Figure 3 ): Gently spread t he side p anels and i nsert t he bottom panel ( C)
into the grooves of side panels (B) until it is fully seated in the groove of the face frame. (A).
4.
Installing the Back Panel and Toe Kick (Figure 5): Before you start this step, put the
back panel (E) on a flat surface facing upward. Install the drawer rail holders (g) i n t h e p r e ‐
spotted area on the back panel (Figure 6). The opening of the holders should be facing towards
each other. Secure them with 2 flat head screws(e) each. (Figure 6). Then put the back
panel (E) at rear of side panels (B) (Figure 5). Align and lock each cam lock. Install the Toe Kick (G)
by locking the cam lock at both ends (Figure 5).
5.
Installing the Shelf: Stand the assembled cabinet upright with the frame facing you. Insert the
shelf clips (d) into the pre-drilled holes on the side panels at the desired height and install the shelf
(F) from the top locking it into the clips.
6.
Installing the Drawer Slide Rails (Figure 7): Insert the drawer side rail (h) back end into the
holder (g) previously installed (Step 4) on the back panel. Then secure the drawer rail front end with
1/2" screws (e) using the pre‐drilled holes in the face frame. ( Repeat this step for both sides.)
7.
Drawer Assembly (Figure 8):
using screws (f). Then assemble the rest parts of drawer box (I) onto the assembled drawer front.
h
Figure 7
8.
Installing the Corner Braces (Figure 9) and inserting the Drawer: Place the corner braces
(b) on each top corner of the cabinet and secure them with the ½" Corner Brace Screws (c).
Slide the drawer into the rails and check the drawer position and adjust slide rail location for
best operation if necessary. Install the bumpers (a) on the door and drawer front.
First assemble the drawer front (H) with drawer box front (I) by
f
I
H
Figure 8
b
Figure 9
Page 3
I
g
E
Figure 6
Figure 1
Figure 2
Figure 3
Figure 4
E
G
Figure 5
g