Cisco WAP351 Посібник із швидкого старту - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Бездротова точка доступу Cisco WAP351. Cisco WAP351 13 сторінок. Reboot and reset factory default settings
Також для Cisco WAP351: Посібник (4 сторінок), Скидання до заводських налаштувань (4 сторінок)
Друкувати сторінку
Slide the Cisco WAP351 into the bracket, placing the cable
S
7
TEP
through the break-out tab found in the back of the bracket. Mount
the Cisco WAP351 with the back panel facing up or facing down.
Connecting the Cisco WAP351
4
The default configuration of the Cisco WAP351 has the Wi-Fi radio turned
off.You must perform the initial configuration using a wired Ethernet
connection.
To connect the Cisco WAP351 to the wired network:
Connect the Ethernet cable to the Ethernet port of a switch, a router,
S
1
TEP
or a PC.
Connect the other end of the network Ethernet cable to the
S
2
TEP
Ethernet port of the Cisco WAP351.
The power adapter is sold separately for the Cisco WAP351. If PoE
S
3
TEP
is not provided, connect the power adapter (48V/1.25 A) to the 48V
DC jack. For more information about the power adapter, see
www.cisco.com/go/wap_accessories.
After installation, all lights should be active. Refer to
Hardware Installation"
WAP351.
Cisco WAP351 Quick Start Guide
for details about the different lights on the Cisco
"Verifying the
5