CABINETS TO GO Findley & Myers CB33 Інструкція з монтажу Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Внутрішнє оздоблення приміщень CABINETS TO GO Findley & Myers CB33. CABINETS TO GO Findley & Myers CB33 9 сторінок. Lazy susan cabinets
Також для CABINETS TO GO Findley & Myers CB33: Інструкція з монтажу (5 сторінок)
Друкувати сторінку
►General Instructions:
Thank you for purchasing a Cabinets To Go product. You are now the proud owner of a high quality product designed
to face the test of daily use and guaranteeing your enjoyment for many years to come.
Carefully read the instructions before starting the installation.
During assembly, please follow all generally accepted safety procedures.
Failure to adhere to the following instructions will invalidate the warranty and Cabinets To Go will decline any responsibility for any
damages caused. Any installation which does not correspond to the instructions may result in defects, malfunctioning parts, significant
damage and/or injury.
Before the assembly begins, check that all appropriate and required plumbing and electrical connections exist.
Before drilling, make absolutely sure that there are no pipes (gas, water,electricity, heating, etc.) at the drilling location. Cabinets To Go will
not be held responsible for failure to follow these instructions.
PRIOR TO ASSEMBLY, PLEASE MAKE SURE YOU HAVE ONE FACE FRAME BOX AND ONE CARCASS BOX, WHICH HAVE ALL THE PARTS IN THE
QUANTITIES MENTIONED BELOW. IF YOU ARE MISSING ANY PARTS, PLEASE STOP AND CONTACT CUSTOMER CARE IMMEDIATELY AT 1-800-
CABINET.
► Items Quantity
Item
Description
Back Left Side Panel
A
Back Right Side Panel
B
Back Panel
C
D
Front Left Side Panel
E
Front Right Side Panel
F
Full Frame
G
Partial Frame
H
Bottom Panel
I
Fixed Shelf
J
Turntables
K
Left Toe Kick
L
Right Toe Kick
M
Right Door
N
Left Door
O
165deg Hinges
P
Turntable Hardware
Hardware Box
Bumper 4pcs, Door Magnets 2pcs, Plastic Corner Brackets 4pcs, ST2.9*16mm Screws 8pcs, ST3.5*16mm Screws 8pcs, ST12mm Screws 8pcs, ST14mm Screws 16pcs
► Required tools:
Tools Required: Phillips Screwdriver
Optional Tools: Electric Drill
► Hardware Box:
a
b
c
8
4
Qty
t
8
Qty
Q
y
The materials listing above are for the largest unit in this instruction set. Smaller units may require less hardware and materials;
therefore, your item may contain a smaller number of each.
Optional Tools: Rubber Mallet
d
e
f
g
8
16
4
2
Q ty
Q ty
Q ty
Q ty
Page 2
Qty
1
1
1
1
1
1
1
1
1
2
1
1
1
1
2
2