Cisco WUMC710 Посібник користувача - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник користувача для Бездротова точка доступу Cisco WUMC710. Cisco WUMC710 17 сторінок. 802.11ac
Також для Cisco WUMC710: Посібник зі швидкого встановлення (17 сторінок), Посібник користувача (17 сторінок)
Linksys WUMC710
WEP
WEP is a basic encryption method, which is not as secure as WPA or WPA2
Key 1
Enter the WEP key of your network
Tx Key
Key 1 is the transmit key used by the media connector
Authentication
The default is Open, which uses open system authentication,
so the sender and recipient do not use a WEP key for authentication Select
Shared to use shared key authentication, in which the sender and recipient
use a WEP key for authentication Select Auto to allow either Open system or
Shared key authentication to be used
Click Save Settings to apply your changes, or click Cancel Changes to cancel
your changes
Wi-Fi Protected Setup
There are two methods available Use the method that applies to the router
you are using
Method #1
Use this method if your router has a Wi-Fi Protected Setup button
1. Click or press the Wi-Fi Protected Setup button on the router
2. Within two minutes, click the Wi-Fi Protected Setup button on the
media connector's Wi-Fi Protected Setup screen
3. After the media connector has been configured, click Close
The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),
and Security method
Method #2
Use this method if your router requests the PIN number of the media connector
1. On the router's Wi-Fi Protected Setup screen, enter the PIN number on
the media connector's Wi-Fi Protected Setup screen Then click Register
or the appropriate button (It is also listed on the label on the bottom of
the media connector )
2. On the media connector's Wi-Fi Protected Setup screen, click OK
3. After the media connector has been configured, click Close
The Wi-Fi Protected Setup screen displays the Link Status, Network Name (SSID),
and Security method
Advanced Configuration
9