Cisco 3515 MCU24 Посібник з встановлення та оновлення - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник з встановлення та оновлення для Конференц-система Cisco 3515 MCU24. Cisco 3515 MCU24 44 сторінки. Cisco unified videoconferencing releases 5.6 and 5.7
Друкувати сторінку
How to Perform the Cisco Unified Videoconferencing 3515 MCU Unit Initial Configuration
Procedure
Connect the RS-232 terminal cable to the PC terminal.
Step 1
Step 2
Connect the power cable.
Start the terminal emulation application on the PC.
Step 3
Step 4
Set the communication settings in the terminal emulation application on the PC as follows:
–
–
–
–
–
Turn on the power to the Cisco Unified Videoconferencing 3515 MCU unit.
Step 5
A log of the auto-boot events appears on the computer.
When the message "Press any key to start configuration" appears on the screen, press any key within six
Step 6
seconds.
The network configuration Main menu appears as follows:
Press any key to start configuration...
Main menu
N: Configure default network port values
P: Change the configuration software password
S: Configure network security level
T: Configure TFTP servers list
A: Advanced configuration menu
Q: Quit
Select:
Caution
At the prompt, enter N to configure default network port values and press Enter.
Step 7
At the Enter IP address for Interface No. 1 prompt, enter the IP address you want to assign to the
Step 8
Cisco Unified Videoconferencing 3515 MCU unit and press Enter.
Caution
Step 9
At the Enter Default Router IP Address prompt, enter the IP address of the router that you want the
Cisco Unified Videoconferencing 3515 MCU unit to use and press Enter.
Caution
At the Enter IP Mask prompt, enter the subnet mask and press Enter.
Step 10
If a subnet mask is not used, press Enter.
•
After you enter the subnet mask parameter, the unit updates the boot line parameter and reboots.
•
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3515 MCU12 and MCU 24 Releases 5.6 and 5.7
2-6
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
If you do not press a key before the countdown ends, the device continues its initialization and
you can only configure the device by pressing the RST button on the front panel.
Do not use leading zeros in the IP address.
Do not use leading zeros in the IP address.
Chapter 2
Setting Up Your Cisco Unified Videoconferencing 3515 MCU
OL-17012-01