Digitana VCS3 MKII Quad Midi-CV Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Digitana VCS3 MKII Quad Midi-CV. Digitana VCS3 MKII Quad Midi-CV 13 сторінок.
Друкувати сторінкуVelocity Assignment in Play Modes
In mono mode velocity assignment is straightforward..just tick the 'VL' box to assign velocity CV
to any of CV2-CV4. On the VCS3 you would want to patch this velocity CV to control the either or
both of the output channel levels (last two columns in the matrix). These channels respond
differently to positive and negative CV..so its advisable to assign velocity to CV3 as you then have
the option on the quad unit to not only scale but also invert this CV. You can then experiment to
find interesting velocity 'curves'.
In poly mode 2 its best to again assign velocity to CV3 by clicking the 'VL' box. If you choose CV4
..the problem is this is only available to the synthi via the black pin cable and thus you can only
control the level of output ch1 or output ch2 by inserting the pin but not both at the same time.
Obviously in poly mode 4 you have no options to assign note velocity or any other midi
parameter to CV as all 4 CV channels are taken up with midi notes.
In experimenting with velocity curves on the VCS3 you will also find it useful to adjust the main
output channel level pots as the setting of these also affects the overall velocity respsonse of the
output channels.
Digitana Electronics, St Albans, England, 2010