Cisco CTS-SX10-K9 Посібник для початківців - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник для початківців для Конференц-система Cisco CTS-SX10-K9. Cisco CTS-SX10-K9 25 сторінок. Telepresence sx10 quick set

Друкувати сторінку

Cisco TelePresence SX10 Quick Set

SX10 Quick Set

IP settings

(When not set by a provisioning system)

On the Setup assistant, you can select the IPv4 settings for the

system. If you wish to change the IP settings from the default

dual stack setting to either IPv4 or IPv6, you can do that on the

web interface.

The system's IP configuration is by default set to dual stack.

This means that the network interface can operate on both

IP versions, and has both an IPv4 and an IPv6 address at the

same time. The IP parameters can be assigned automatically

by the network, or you can set everything manually.

If you want to set the parameters manually, please contact your

network administrator to obtain the required parameters.

If your system is provisioned automatically, these IP settings

may be overridden by the provisioning system.

If an IPv4 or IPv6 address is already assigned to the system,

you will find it under Settings: Navigate to the user name in the

upper left corner and select

Settings.

To change the IPv4 settings for the call, navigate to the user

name in the upper left corner and select Settings. Select

Assistant, and proceed to the IPv4 section.

Back to task overview

D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.

Contents

Introduction

Select

want automatic IP assignment; or

want to set the IP addresses manually.

If IP Assignment is Static: Set the IP addresses

Setup

Enter the

address. A soft keyboard appears when you

select an input field. Select ⎷ to confirm the

change

Configuration

Choose automatic or manual IP assignment

DHCP

in the

IP Assignment

section if you

Static

if you

Address,

Subnet Mask

and

Gateway

Select

to save the changes.

Getting Started Guide

Appendices

Contact