ACU-RITE Forecaster 00823 Інструкція з експлуатації - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Метеостанція ACU-RITE Forecaster 00823. ACU-RITE Forecaster 00823 4 сторінки. Forecaster with wireless thermometer

Друкувати сторінку

4 • OPERATION

After the main unit and the wireless sensor are both powered on and wirelessly

synchronized, no further input is required. If you have problems receiving the

outdoor temperature, please refer to the troubleshooting section of this manual.

Minimum/Maximum Recorded Temperatures

The main unit has a memory function for storing minimum and maximum recorded indoor

and outdoor temperatures. You may view the MIN and MAX recorded temperatures by

pressing the "MIN/MAX" button on the back of the main unit.

Trend Indicator Icons

The main unit features arrow icons for indicating a falling, steady or rising temperature.

This feature is shown for the outdoor and indoor temperatures.

MIN

ºC/ºF

MAX

RE-SYNC

14 Day Learning Mode

This weather station has a patent pending

fourteen day learning mode calibration process.

During this learning mode, the weather station

will make altitude calculations that may affect

the accuracy of the forecast icon. After the initial

14 day learning period, the forecast feature will

be ready for superior operation.

Forecast Icon

This feature gives you the predicted weather

forecast for the next 12 to 24 hours based on an

advanced algorithm that includes barometric

pressure and temperature. This weather station

will provide the most accurate forecast that a

single station weather instrument can provide.

Re-Synchronize Wireless Signal

This weather station features a button for

re-synchronizing the wireless signal with the

outdoor temperature sensor. Press this button to

attempt to re-synchronize in the event you lose

connection with the outdoor sensor due to

interference or battery changes.

ºC/ºF Selection

Press this button to switch between ºC or ºF

temperature scale selections.

- 4 -

5 • TROUBLESHOOTING

This product features a low power wireless signal, so it does not interfere

with other wireless devices in your location. Occasionally, there will be a

temporary disconnection to the wireless sensor. In most cases, the

temperature will show again if the main unit and wireless temperature

sensor are able to re-connect automatically. If the disconnection lasts longer

than a few hours, refer to this troubleshooting guide.

Problem

Bad Temperature

Reception

FLASHING TEMPERATURE

Main Unit

Display Not Working

Extended periods of cold temperatures ( below -4ºF / -20ºC )

can cause alkaline batteries to function improperly. This will

cause the outdoor wireless sensor to stop transmitting

temperature readings. Use lithium batteries in these low

temperature conditions to ensure continued operation for

wireless sensors placed outdoors.

To receive product information, register

your product online. It's quick and easy!

Log on to http://www.chaneyinstrument.com/product_reg.htm

Possible Solutions

Relocate the main unit and/or the wireless

sensor. Both units must be within 100 feet

from each other. Make sure both units are

placed at least 3 feet from other electronic

appliances and devices that may interfere

with the wireless communication (such as

TV's, microwaves, computers etc).

You may need to press the "RE-SYNC"

button on the back of the main unit.

NOTE: It may take up to 20 minutes for the

main unit to re-synchronize with the sensor

when batteries are replaced.

Make certain that the batteries are installed

correctly. The batteries may need replacing.

If none of the above solutions resolve the

problem, you may need to reset both units

by removing and re-installing the batteries

in both unit.

Product Registration

- 5 -