Cisco TelePresence MX700 Посібник - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник для Конференц-система Cisco TelePresence MX700. Cisco TelePresence MX700 45 сторінок. Single camera on a free standing floor stand or a floor stand secured to the wall
Також для Cisco TelePresence MX700: Посібник з монтажу (32 сторінок), Посібник із швидкого старту (12 сторінок), Посібник з монтажу (28 сторінок), Посібник з монтажу (29 сторінок), Посібник з монтажу (32 сторінок), Короткий довідник (2 сторінок), Посібник (45 сторінок), Посібник з монтажу (29 сторінок), Короткий довідник (2 сторінок), Короткий довідник (2 сторінок), Посібник для початківців (46 сторінок)

Друкувати сторінку
Cisco TelePresence MX700 Посібник
Commands and Statuses
Table of contents
The
essential when working with in-room controls:
Introduction
xCommand UserInterface Extensions Widget SetValue Value:
When the video system receives a
Create a user interface
system's status and the Touch 10 in-room control panel are updated
accordingly.
It is important that the control system sends
API for in-room control
API for in-room control
the following situations, so that the Touch 10 in-room control panel
truly reflects the status of the room:
• When the control system initially connects to the video system.

Widgets

• When the video system restarts.
• When the control system restarts.
Command reference
• When a new in-room control panel is exported to the video
• When someone physically changes something in the room, for
Troubleshooting
• As a response to an event, for example when someone has
Tips and tricks
Examples
Consult the
apply to the different widgets (user interface elements).
In-Room Control on Touch 10
for Cisco TelePresence
MX200 G2, MX300 G2,
MX700, MX800,
SX10, SX20, SX80
Collaboration Endpoint
software version CE8.2
D15358.02 - JULY 2016
www.cisco.com
© 2016 Cisco Systems, Inc.
All rights reserved.
command, which sets the value of a widget, is
SetValue
WidgetId
WidgetId:
SetValue
system from the in-room control editor (as response to the
LayoutUpdated event).
example turns on the lights using a wall control.
tapped the Lights On button on the Touch 10 in-room control
panel.
The control system must also do all that is necessary in the room
to reflect the action on the Touch 10 in-room control panel, for
example switch on the light.
Widgets
chapter for more details about which commands
Examples
Value
command, the video
commands in
SetValue
18
Video system
User
with Touch 10
Tap Lights On
Pressed and
Released events
for Lights On
widget
Set the value of
The appearance
the Lights On
of the light widget
widget to active
has changed to
match what the
user can see in
the room
Message flow—turn on the lights using the controls on Touch 10
Video system
Control
User
with Touch 10
system
Set the value
Signal that
of the Lights
lights are on
The
On widget to
appearance
active
of the light
widget has
changed to
match what
the user can
see in the
room
Message flow—turn on the lights using the wall control
Control
system
Lights
Turn lights on
Lights
User
Turn lights
on with wall
control